Even the arbor thread is specially designed being modified Acme thread having a large flat surface so that it will accurately center the saw blade, cutter heads, etc. Insert the screw through the hole in the motor cover clip and thread the screw (A) into the tapped hole in the motor cover. Massive True-Running Arbor: The Unisaw arbor was an accurately ground shaft with a large flange. Place a 13/64 flat washer on a 10-32 x 1/2" screw (A) Fig. Align the hole in the motor cover clip with the hole in the motor cover. The spring clips come attached to the “GPE version Unisaw.Īttach the two motor cover clips to the motor cover. This left-tilt version of the famous DELTA Unisaw has a computer-designed motor cover, a miter gauge, and a 4-inch dust connector that will fit most common vacuums. NOTE: If you have an “LVC” (Starter Box) version Unisaw, you will have to attach two bottom spring clips to the motor cover. The DELTA 36-元1X-BC50 X5 10-inch Left Tilt 3 Horsepower Cabinet Saw lets you bevel rip single-sided laminate without any problems thanks to its powerful 3 HP motor. 29.įASTENING THE MOTOR CORD TO THE SAW FRAME 3 V-belt drive built-in dust port hinged motor cover the largest cast.
29 to the saw frame cross member (B), using the cable tie (C) supplied with the saw.ĬAUTION: Before tightening the cable tie, make certain that the electrical cord (A) is free of any interference from the motor or saw blade in all positions.Īfter the cable tie is tightened, cut off the excess tail (C) Fig. were thinking of buying a Delta Unisaw or a Powermatic 66, think again. Project requires one 2 x 4 piece of 1/2 plywood, a 18 piano hinge, basic shop tools, and a few. Then turn the angle adjusting handle on the front of the saw clockwise as far as it will go.įasten motor cord (A) Fig. The cover encloses the motor for improved dust control. Raise the saw arbor by turning the height adjusting handle on the front of the saw counter-clockwise as far as it will go.
Tighten all splitter mounting hardware (D) Fig. Tablesaw, table saw, Delta, Rockwell, Unisaw, cabinet, contractor. 27 and 28 to make certain that the saw blade (B) Fig. The splitter (P) is aligned with the saw blade (B).